LT3597
OPERATION
The LT3597 uses a constant frequency, internally com-
pensated peak current mode control scheme. Operation
is best understood by referring to the Block Diagram in
Figure 1.
Enable and undervoltage lockout (UVLO) are both con-
trolled by a single pin. If the pin falls below 1.51V, an
accurate comparator turns off the LED drivers and buck
regulators. If the pin continues to fall to less than 0.4V,
the part enters shutdown and consumes less than 2μA.
The LT3597 contains three constant current sink LED
drivers. Each of the three LED strings is powered from
a dedicated adaptive buck converter in order to achieve
maximum efficiency. The frequency of the buck regulators
is programmed from 200kHz to 1MHz using an external
resistor. The frequency can also be synchronized to an
external clock using the SYNC pin.
Internal buck compensation and soft-start requires few
external components and permits simple board layout. A
high-side switch current limit protects the internal switch
during its on time, while a low side current limit prevents
the switch from turning on in the case of excessive off
phase current.
Step-Down Adaptive Control
Adaptive control of the output voltages achieves superior
system efficiency. When a given channel’s PWM pin is
low, the respective buck regulator output will go to a
programmable high output voltage. In this case the buck
will enter into a pulse-skipping mode since there is no load
connected. This guarantees that the buck output voltage
is high enough to immediately supply the LED current
once the string is reactivated. As soon as PWM goes
high, the output voltage of the buck will drop until there
is 1V across the LED current sink. This scheme ensures
the best efficiency for each LED channel. Since each LED
string is independently driven from a separate buck chan-
nel, efficiency is optimized for all three strings even if the
number of LEDs is mismatched between the channels.
Another benefit of this regulation method is that the LT3597
starts up with 10,000:1 dimming even if the PWM1-3 pulse
width is 1μs. Since V OUT starts up even if PWM1-3 is low,
the part achieves high dimming ratios with narrow pulse
widths within a couple of PWM1-3 clock cycles.
LED Current
Each LED string current can be individually programmed
up to a maximum of 100mA with a 2% matching accuracy
between the strings. An external resistor on the I SET1-3 pin
programs the max current for that string. The CTRL1-3
pin can be used for analog dimming. Digital PWM can be
programmed using the PWM1-3 pin. A dimming ratio of
10,000:1 can be achieved at a frequency of 100Hz.
Fault Protection and Reporting
The LT3597 protects against both open LED and shorted
LED conditions. If the LED1-3 pin voltage exceeds 12V
while the LED string is sinking current, or if the LED1-3
pin voltage is within 1.25V of V OUT1-3 pin voltage, the
channel is disabled until the fault is removed. If the LED
string opens, the LT3597 will limit the output to the voltage
set by the FB resistor divider.
The LT3597 reports a fault on the FAULT pin if any of the
LED strings is open or shorted. LED faults are only reported
if the respective string PWM signal is high. A fault is also
reported if the internal die temperature reaches the T SET
programmed derating limit.
3597fa
10
相关PDF资料
LT3598IUF#PBF IC LED DRIVR WHITE BCKLGT 24-QFN
LT3599IFE#PBF IC LED DRVR WHITE BCKLGT 28TSSOP
LT3743EFE#PBF IC LED DVR HP CONST CURR 28TSSOP
LT3745IUJ#TRPBF IC LED DVR 16CH 50MA 40QFN
LT3746IUHH#TRPBF IC LED DRIVER 32CHANNEL 56-QFN
LT3754IUH#TRPBF IC LED DVR 16CH 50MA 32QFN
LT3755EMSE#PBF IC LED DRVR HP CONS CURR 16-MSOP
LT3760EFE#PBF IC LED DVR WHT/CLR BCKLT 28TSSOP
相关代理商/技术参数
LT3597EUHG#TRPBF 功能描述:IC LED DRIVER 60V TRIPLE 52-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3597IUHG#PBF 功能描述:IC LED DRIVER 60V TRIPLE 52-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3597IUHG#TRPBF 功能描述:IC LED DRIVER 60V TRIPLE 52-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3598 制造商:LINER 制造商全称:Linear Technology 功能描述:60V Triple Step-Down LED Driver Programmable Temperature Protection
LT3598_1 制造商:LINER 制造商全称:Linear Technology 功能描述:6-String 30mA LED Driver with 1.5% Current Matching
LT3598EFE#PBF 功能描述:IC LED DRVR WHITE BCKLGT 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3598EFE#PBF 制造商:Linear Technology 功能描述:LED DRIVER BOOST PWM 2.5MHZ 制造商:Linear Technology 功能描述:LED DRIVER, BOOST, PWM, 2.5MHZ, TSSOP-24
LT3598EFE#TRPBF 功能描述:IC LED DRVR WHITE BCKLGT 24TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极,PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND